Installling A Light Bar On Your Jeep Wrangler

Have you ever wanted to do a little DIY work on your Jeep, but not too sure where to start? Then you have to meet Carlos Dos Santos, a third generation mechanic at Brooklyn Motor Works! When Carlos thinks of a new DIY project he immediately turns to eBay Motors to make sure they have the parts…if they don’t, then the part doesn’t belong on any car.

Once you are ready to upgrade you are going to want to start by mounting the brackets on the window pillars, six bolts. And then there is the light bar with two bolts on either side. The wires will be run behind the window bracket and down behind the firewall. A switch will be installed by the diver’s side to operate the lights and you are ready to go!

Just remove the old flood lights and getting ready to install the new light part kit. The kit comes with gaskets that are hard to keep in position while you are fitting the bracket. *Tip: use a little bit of clear tap to hold them into position and line the holes up.

At the end of the day you really have the creative ability to customize your car and eBay motors allows you to make those customizations…check it out!